11
Positive / negative power supply cable ___________________
___________________4 AWG
Output cables wire gauge_______________________________
________________11 AWG
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Remote cable ___________________
______________________________________ 18 AWG
Protection fuse or circuit breaker
____________________________________________100A
Installation
Recommended wire gauge & fuse
CAUTION: All connections to power supply, input and output connectors must
be carried out only with amplifier off.
CAUTION
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
*Illustrative images
CAUTION
12V
Note: Required battery bank capacity:
At least 150Ah
DISJUNTOR
21mm² (4 A
WG)
21mm² (4 A
WG)
Subwoofer /
Woofer 4 ohms
GND
Remote Cable 0,75mm²
RCA Cable Taramps
RCA Cable Taramps
Output connection example: Bridged
Note:
In case of compression driver and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer’s manufacturer manual).
4 ohms
4 ohms
4 ohms
4 ohms
For connection to Automatic Remote,
see page 03.
CAUTION
The entire aluminum surface of the
amplifier serves as a heat sink. Therefore,
avoid contact with this surface when the
amplifier is in use.
Head Unit
If the head unit doesn't have the 4 RCA outputs,
use ‘‘Y’’ type cable adapters for properly 4 inputs
connection of amplifier.
