11
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Remote cable ___________________
______________________________________ 18 AWG
Output cables wire gauge_______________________________
_________________7 AWG
Protection fuse or circuit breaker
____________________________________________600A
Positive / negative power supply cable ___________________
_______________2 x 2/0 AWG
Installation
Recommended wire gauge & fuse
CAUTION: All connections to power supply, input and output connectors must
be carried out only with amplifier off.
CAUTION
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
CAUTION
70mm² (2/0 A
WG)
70mm² (2/0 A
WG)
12V
GND
GND
12V
CIRCUIT BR
AKE
10mm² (7 AWG)
10mm² (7 AWG)
Note:
In case of compression drivers and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer’s manufacturer manual).
Examples of connections in the power supply input.
Note: Required battery bank capacity: At least 600Ah
*Illustrative Images
Remote Cable
18AWG
Head Unit
RCA Cable
Taramps
CAUTION
The entire aluminum
surface of the amplifier
serves as a heat sink. Therefore, avoid
contact with this surface when the
amplifier is in use.
This equipment is not
suitable for use in places where children may
be present.
CAUTION
