Tar River DRL-072, Руководство оператора

Страница: 11 / 38

11
7. Install Cage Roller on both Roller Arms. Ensure Grease
Fitting is to the outside. Secure in place with nuts and cotter
pins.
8. Install lower arm brackets onto frame 4 total 2 on each side
as well as smaller sprocket screw side facing out.
9. Install chain on both sides, pull box back to tighten chain
then tighten box bolts,
10. Install chain guard on both sides.
11. Remove cotter pins and one washer from rollers place folding arms on rollers and replace
the washers and cotter pins then install folding arms in end holes. Use 4 - inch bolts with
lock - washers. Bolt to frame.
12. Install spring board to end.
13. Install walk board.
14. Install box lid opening towards 3 points
15. On the open/close wheel on each side remove cotter pin and replace with a roll pin after
installing pin make sure to open and close both sides to verify that all doors are functional.
(Initially the adjustment regulator will be tight, it helps to turn the rear adjustment roller
before and during this procedure).
9