Tapworks Ultra 9, Руководство пользователя и инсталлятора

Страница: 6 / 28

Please Remember
–
Only use tablet or pellet salt in your softener! 6
Step-by-step guide to plumbing the softener
Note: If you need to remove the valve cover for ease of installation,
remove salt lid, then simply release the two catches behind the valve
cover and tilt top end towards you slowly, taking care not to pull off
the wire connections.
Please note that the valve cover is connected to the valve motor, so
cannot be removed fully.
PLUMBING
Turn off the water supply at the incoming main and begin plumbing
as per the installation instructions on pages 4 and 5.
FIT THE BYPASS KIT
Cut off the rising main and install the inlet tee with check valve using
15mm reducer if required. Next, plumb the bypass, inlet and outlet
valves and outlet tee, using 15mm reducer if required, so that the
water supply can be turned back on. Use the threaded valves for the
inlet and outlet and the compression valve for the bypass. Before turning
the water back on, make sure the bypass is open and the inlet and
outlet valves are closed. This will allow water to pass directly to the
household system without it diverting to the water softener. See Valve
Hard Water Bypass position diagram below.
(The use of the plastic plumbing fittings with copper pipe may affect the electrical earthing
or bonding of the copper pipe. If in doubt, we advise that you contact a qualified
electrician for advice).
To bypass softener, ensure bypass is open (horizontal) as per right
hand diagram below.
Hard Water Bypass Position
Inlet tee
incorporating
check valve
Inlet closed
Bypass open
Outlet closed
15mm reducer
(if required)
To system From mains
To water
softener inlet
From water
softener outlet
15mm reducer
(if required)
Valve Service Position
15mm reducer
(if required)
Inlet tee
incorporating
check valve
From mains
Inlet open
Bypass closed
Outlet open
To system
To water
softener inlet
From water
softener outlet
15mm reducer
(if required)