SETVALUE RECALL
While TX2 is running/ waiting for inputs, set value/
values can be recalled (viewed) without disturbing the
timing process.
Briefly press the
button on the TX2 timer.
1. If the configured mode is
or
the display
will show the set value for one second.
2.
If the configured mode is
or
the display will
show
and its set value followed by
and
its set value.
CONFIGURATION RECALL
While TX2 is running/ waiting for inputs pressing the
button for 3 seconds causes to display to show
the configuration setting of parameters 1 to 6 one
after the other.
CONFIGURATION
TX2 is a multifunctional timer. To make it function in
the desired way it has to be
configured
.
Configuration can be done through the front panel
buttons.
To
enter into the configuration
mode.
1.
Remove power to the instrument.
2.
Keep the
button pressed
3.
Apply power.
4.
Leave the button when the display shows
.
5.
Navigate the configuration parameters using
and
buttons.
To
change parameter value
6.
Press the
button to enter that parameter.
7.
The display shows the value of that parameter.
8.
Using
and
buttons change to the
desired value.
9.
Using
button exit that parameter.
10.
Similarly other parameters can be changed.
To
save the changes and exit the configuration
mode
11.
Navigate using
and
buttons (to the
parameter) when the display shows
.
12.
Press the
button.
13.
The TIMER is now updated with the new
configuration and is ready to be used.
Configuration Parameters
#
Name.
Setting range for parameter
Seconds
Minutes
1
Time
Units
Hours
9.99 When
Time units
is set
to seconds
9.59 When
Time units
is set
to Minutes or Hours.
99.9
2
Range
999
UP
: Once the timer starts
the display increases from 0
to S
et value
.
3
Directio
n
DOWN
: Once the timer
starts the display decreases
from
Set value
to 0.
On delay
Interval
Cyclic
with
ON
time
first
.
4
Mode
Cyclic
with
OFF
time
first
.
Reset by front panel
Enable
.
5
Front
Reset
Reset by front panel
Disable
.
Output 2
follows
Output 1.
Output 2
pulses
on for
750ms when
START
input is
given.
6
Output
2
Output 2 is
opposite
off
Output 1.
Normal
: To start a new
cycle a
RESET
input has to
be given.
7
Reset
Auto
: A new cycle can be
started without first giving a
RESET
signal.
Level
: The
START
input can
be closed permanently and
the timer will always read it
as start input present.
Gate
: When
START is open
the relay state does not
change but the
time
counting stops
. On make
of
START
contact time
counting starts from the last
time count.
8
Start
type
Edge
: Timing starts on
application of
START
input
(Open to Close).
Exit
Config
On pressing
button
at this
parameter configuration is saved and
timer goes into normal operation.
