TapFlo DT Series, Инструкции по установке, эксплуатации и техническому обслуживанию

Страница: 11 / 22

IOM manual Active pulsation dampeners 11
2. MAINTENANCE
!
Fig. 2.5.4.
Screw the shaft ending [1652] into the diaphragm [15].
Note!
It is very important to screw the shaft ending(using an allen
key) as deep as possible so it won’t have the tendency to unscrew
during operation.
Fig. 2.5.5.
Screw the diaphragm [15] with the shaft ending [1652] onto the shaft
[1651].
Note!
When the diaphragm is screwed in, the holes in the diaphragm
must be aligned with the holes in the block.
Fig. 2.5.6.
Push the diaphragm [15] in, so that it is touching the dampener
block [12].
Fig. 2.5.7.
Put the pin screws [14] and washers [38]into the dampener housing
[11].
Fig. 2.5.8.
Screw the nuts [37] onto the pin screws [14] so that ca. two threads
are visible over the nut.
Fig. 2.5.9.
Turn over the dampener housing [11] and insert the dampener block
[12] onto the pin screws [14].