S n a p S t a n d
Setting up your Snap Stand
®
STEP 1
To open each Leg Set, push in the snap button and move each leg outward to the working
position. Figure 1A below shows the leg set as shipped while Figure 1B shows the leg set
open (working position). Make sure that the snap button pops up to lock each leg.
STEP 2
Attach the Cross Braces to the Leg Sets. With the snap
button of the Leg Set pointing to the outside, snap the
Cross Braces into position. See Figures 2A and 2B below.
Note: Be sure the C-shape of the
Cross Brace is mating the leg as
shown in Figure 2C below.
Snap Button locations
when legs are closed.
Snap Button locations
when legs are open.
Attaching Optional Wheel Kit
STEP A
Insert the wheel assembly into the leg of
the Snap Stand as shown in the figure
above. Tap the bracket with a hammer to
wedge it tightly into the leg. Repeat this
process for the other leg.
STEP B
To prohibit the stand from rolling on the wheels, lock the leg ex-
tensions into one of the bottom two locking positions. See figure
above. If the leg extensions are in one of the other 3 positions, the
wheels are in contact with the ground and are free to roll.
STEP C
To remove the wheel
assembly, tap the
bracket downward with
a hammer to disengage.
Use one of these
positions to stop the
stand from rolling.
Figure 1A
Figure 1B
Figure 2A
Figure 2B
Figure 2C
1
