BlinkerBeam™ Radio Operation Guide
6
QUICK SETUP
1. To access Quick Setup, push the joystick in any direction to access the
radio’s MAIN MENU on the display, and use the joystick to scroll to
and select
0) Quick Setup
.
2. Set mode. See Figure 5.
Select transmitter or receiver. See Figure 6.
For more information, see “Set The Operation Mode”.
NOTICE
Close proximity of some antennas can cause interference.
If another TAPCO system is located within a 1 mile radius (or 40
miles if it has an Omni or a Yagi antenna) of this system, ensure
each system
uses its own Hop Channel and binding code by
selecting a different QBind# or by manually binding with a different
number code.
A radio must have the same binding code and hop channel as
every other radio in the network.
Only one radio can be set as the Transmitter.
3. Set QBind1 or another QBind number in the QUICK SETUP menu.
See Figure 7.
QBind uses preset binding codes (i.e., QBind1=01111111 or
Qbind2=02222222). The QBind also changes the hop channel to
the associated number (QBind1 sets the hop channel to 1, and
QBind2 sets the hop channel to 2.).
After the BINDING SAVING indication displays, The QBind option
on the QUICK SETUP menu should now have an arrow on the
right side of it.
For more information, see “Set Bind Codes” and “Set Hop Channel
Menu”.
4. If one needs to manually set a bind code, use the joystick to scroll
down to and select
ManBind
in the QUICK SETUP menu.
See Figure 8.
Select the coding digits.
Notes:
The digits on the display begin at the seventh digit and decrease
to the right.
Figure 8
Figure 7
Figure 6
Figure 5