Following these guidelines will help ensure that your Taoglas
TGX.04 antenna is installed correctly. The TGX.04 can be mounted
via 3 different variations; wall mount, pole mount and suction
cup mount. All mounting methods are outlined below.
TGX.04 Series
MIMO 5G/4G Antenna
Installation Instructions
Introduction
Installation
Requirements
IG-21-8-020-A
Pole Mount
•
7mm [9/32”] socket wrench/ screwdriver
•
Metal mounting clamp (x2)
•
Pole diameter range: 22mm [0.9”] -
50mm [2”]
Wall Mount
•
Screwdriver
•
Drill
•
M4 [Gauge 8] screw (x4)
•
M4 [Gauge 8] washer (x4)
•
6mm [1/4”] wall mount stud (x4)
Suction Cups
•
D40 suction cups (x4)
Antenna Components: Mounting Plate (x1), Tightening Nut (x1), Antenna Housing (x1), Coaxial Cable(x4)
All copyrights, trademarks and any other intellectual property rights related are owned by Taoglas Group Holdings Limited.
Caution
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device must be installed
to provide a separation distance of at least 20 cm from all persons to satisfy RF exposure compliance.
Warning
Do not
Operate the transmitter when someone is within 20 cm of the antenna.
Do not
operate the equipment in an explosive atmosphere.
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them away into standard waste.
Notices
Suctions Cups
This antenna should be mounting with suction cups for indoor use only.
Directive (RoHS) 2011/65/EU / 2015/863/EU
Harmonised Standards and References:
EN 301 489-1 (V2.2.1):
ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical
requirements. Referencing CENELEC EN 55032 Class B.