Tao Motor DB-20, Руководство пользователя

Страница: 17 / 21

10.Review and adjust valve clearance
•
•
Check the pads are not worn to the limit as may be dangerous to drive in this
condition.
•
This unit has disc brakes, making them bleed able.
•
The Valve may be damaged and the engine power decreased. Check brake lines
for wear, leak and damage. Replace damage arts with all new parts.
11. Brake Review
Operate front & Rear Brakes Verify for proper operation.
•
Check the pads are not worn to the limit as may be dangerous to drive in this
condition.
•
This unit has disc brakes, making them bleed able.
•
Check brake fluid level periodically.
•
Check Brake lines for wear, leaks and damage
•
Replace damage arts with all new parts
Cleaning the dirt bike
Clean dirt bike regularly.
The water pressure can damage many parts of the dirt bike, therefore not wash the following parts with a pressure washer : wheel hub,
stop switch, fuel tank and the portion of seat, carburetor, ignition switch, etc.
1.
After the dirt bike has been cleaned, rinse with fresh water. We recommend shampoo used as any other detergent is detrimental to the
paint contain degreasing agents ammonia or caustic.
2.
Dry the dirt bike.
3. Run the engine idling for a few minutes.
4. Check the brakes several times before riding dirt bike, and make repairs or adjustments if necessary.
Procedure during storage
•
Be careful to prevent your bike from moisture, sun and rain and avoid unnecessary damage.
•
Check the main parts of the dirt bike before storage.
•
To maintain the dirt bike in normal course storage:
1. Replace engine oil with new.
2. Drain the remaining gasoline from the fuel tank and carburetor.
Then spray with anti-rust oil the inner fuel tank and close the tank lid.
3. The carburetor gasoline must be drained.
•
As the gasoline is flammable, the engine must be switched off during filling and emptying of the fuel.
•
Do not be lit cigarettes, sparks fire where fuel is empty or where fuel is stored or where the dirt bike is filled with gas.
4. Remove the spark plug
5. Remove the battery from the dirt bike. Place the battery in a safe place where it will not freeze or expose to UV sun. Charge the battery
once a month. (No more than 2 Ah charger)