DIAGRAM 4:
Leveling the Template
3
stud-finder tool is highly recommended for this pro-
cedure. The speakers should be centered between
the two 16" on center studs. Make sure that there are
no studs or obstructions where you plan to install the
speaker.
3. Trace Template.
Place the cutout template at the
location you have decided to place the speaker.
Keep in mind that the flange of the speaker will
extend beyond the cut opening by 1⁄4". Center the
template between the studs. With the template in
place, use a level along the top or bottom edge to
make sure it is even with the floor and ceiling. Use a
few pieces of tape or small tacks to hold the template
in place.
(DIAGRAM 4)
Trace an outline on the wall
with a pencil.
4. Cut the Hole
.
CAUTION: This is the most important part
of the entire installation.
If you are not certain whether
or not an obstruction exist behind the desired mount-
ing area, you should start by cutting a small hole in the
center of your penciled mounting hole with a drywall
saw. Cut at a 45˚ angle towards the inside of the hole.
(DIAGRAM 5)
Cutting the small hole at this angle will
make drywall repair much easier as the piece cut out
can be installed neatly back into the hole. Once you
have determined that there aren’t any obstructions
in your desired mounting location, start cutting the fin-
ished hole at a 90˚ angle to the wall surface.
WIRING THE TANTRA ON-WALL SERIES
NOTE: All the connections should be made with the
equipment switched off.
(DIAGRAM 6)
Attach the
speaker cable to the speaker terminals, observing
the proper polarity with your amplifier, + to + and
– to –. Make sure to connect the speaker ouputs from
your amplifier to the correct speaker.
PAINTING THE GRILLES
The grille and grille frame can be painted by using 5
part thinning agent to 1 part paint. Great care should
be taken not to clog the holes as this will greatly reduce
the sound quality of the speaker. If it is necessary to
paint the grille under cloth material, follow the same
procedure used to paint the grille.
NOTE: The under cloth material must be removed before
painting
. To re-install it we recommend using a spray
adhesive to keep it in place. Be very careful not to
overspray the undercloth because it could block the
sound.
GRILLE
The grille is magnetically attached to the cabinet
and can easily be removed by gently prying the grille
forward.
DIAGRAM 5:
Wall Cut Out
DIAGRAM 6:
Terminal Cup
DIAGRAM 7:
Inserting Lag Screws
SPEAKER INSTALLATION
1.
Using the drywall as support, gently slide the cabinet
into the hole cut-out.
2.
Insert the lag screws included with the packaging
into the cabinet's screw holes and secure the cabinet
to the studs.
(DIAGRAM 7)
We
highly
recommend pre-
drilling each hole as that would allow the lag screws to
penetrate easier without creating knots in the stud.
Содержание Tantra 8 LCR
Страница 1: ......
