C a ut i on
When using Tansun electrical heaters, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
Read all instructions before using this heater.
•
Before using this appliance:
- Check that the voltage indicated on the type plate corresponds to the
mains supply voltage.
- Ensure that the heater has been securely fastened in its final mounting
position.
•
Do not locate the heater immediately below a socket outlet.
•
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by
children without supervision.
•
Children of less than 3 years should be kept away unless continually
supervised.
•
Children aged from 3 years and less than 8 years shall only switch on/
off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
•
CAUTION - Some parts of the product can become very hot and
cause burns. Particular attention has been given where children
and vulnerable people are present.
•
Remove the plug from the mains socket (or disconnect pole switch)
during installation, cleaning and/or replacing the element and always
ensure that the element is cool.
2
7
4. At the back of the heater, remove the plate holding the terminal box by removing the two fixing screws as shown in
Fig. G.
5. Pull the emitter wires one at a time through the plate to remove as shown in Fig. H.
6. At the front of the heater, the guard in front of the emitter you are replacing should be removed by gently pulling it
away from the heater so it prises out of its locating holes at each end (Fig. J).
Fig. G
Fig. H
Fig. J
Fig. K
7. Remove the screw (Fig. K) from the side reflector and lift it up away from the heater to remove it. Repeat at opposite
end to remove other side reflector.
