Tannoy i9, Руководство пользователя, Страница: 5 / 14

Figure 4d : Series Parallel Combination: 8
Ω
When operating in low impedance mode the rotary switch on the back of the cabinet as
shown in
Figure 4a , below should be set to ‘8 ohm’
Figure 4a
100V
A
70V
B
D
C
8ohm
OFF
Transformer Tappings
A
B
D
C
7.5W 15W
30W
60W
15W
60W
30W
4.1. Connectors & Cabling for Low Impedance Operation
The i9 is fitted with 4-pole Neutrik Speakon

connectors. Speakon has the following
advantages over EP and XLR type connectors: All terminations are solderless; this
makes life easier at the time of installation or when field servicing is required. Contacts
will accept 6 sq. mm wire with an outside diameter of up to 15mm and a current rating
of 30 Amps. The pins of the 2 Speakon sockets identified input/output on the rear of the
input panel are paralleled within the enclosure. Tannoy have adopted the conventional
wiring standard for the i9 product :-
Pin 1+ is Positive
Pin 1- is Negative
For a worldwide list of Neutrik distributors see http://www.neutrik.com/
5