PROV APPLICATOR MAINTENANCE
O-RING SEAL
FLUID
NOZZLE
ADJUSTABLE
NOZZLE
RETAINING
RING
TROUBLESHOOTING - BLOCKED NOZZLE OR CONTINUOUS SPRAY WITHOUT PRESSING THE TRIGGER
STEP 1 -
Locate and unscrew retaining ring. To release; turn retaining ring in an anti-clockwise motion.
STEP 2 -
Gently pull on the adjustable nozzle to remove.
STEP 3 -
Gently remove the metal disc and spring.
STEP 4 -
Fit an 8mm spanner to the flat edges of the fluid nozzle and turn anti-clockwise to unscrew.
STEP 5 -
Ensure you do not misplace the o-ring seal, which is located behind the fluid nozzle .
STEP 6 -
Once removed, visually inspect the fluid nozzle for small particles or blockages -
rinse thoroughly with hot water.
STEP 7 -
Gently wipe the fluid needle to clean and remove any debris. (the fluid needle should not be
removed from the applicator at any time)
STEP 8 -
Once visually clear of any debris, re-attach fluid nozzle, ensuring the O-ring is in position, then
use the spanner
(8mm)
to gently tighten back into place.
STEP 9 -
Replace spring, then gently insert metal disc ensuring the grooves on the disc line up with the
sides and the raised front is forward facing.
STEP 10 -
Replace adjustable nozzle and rotate back into position.
STEP 11 -
Repeat previous step, this time with the retaining ring.
FLUID
NEEDLE
METAL
DISC
SPRING
