Tanita BC-G01, Руководство пользователя

Страница: 10 / 12

8
en
Guest mode allows you to program the monitor for one-time use without reading a personal data
number.
Press the Guest button to activate the monitor, and then set the age, select Female or Male and
specify the height.
Step onto the monitor after “0.0” is shown on the display. The weight is displayed first. Continue
standing on the monitor until the Body Fat % reading is shown on the display. The reading is
displayed for 40 seconds.
Note: Do not step off until the Body Fat % is shown.
Note:
If you step onto the monitor before “0.0” appears, “Err” appears on the display and readings
cannot be obtained.
Programming the Guest Mode
Press the Weight-only button. After 2 to 3 seconds, “0.0” appears on the display and the monitor
beeps. When “0.0” appears on the display, step onto the monitor. The body weight reading appears.
The display lights for about 20 seconds, after which the power turns off automatically.
Taking Weight Measurement Only
If the following problems occur ...then...
• The wrong weight format appears followed by kg, lb, or st-lb
Refer to “Changing the Weighing Unit” on p.5.
• “Lo” appears on the display, or all the data appears and immediately disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately since weak batteries affect the accuracy
of your measurements. Replace all the batteries at the same time with new AA-size batteries.
Note: Your settings are not erased from the memory when you remove the batteries.
• “Err” appears while measuring.
Please stand on the monitor and keep as still as possible.
The monitor cannot accurately measure your weight if it detects movement.
The monitor cannot take measurements if the Body Fat Percentage is higher than 75%.
• The Body Fat Percentage reading does not appear or “-----” appears after the weight is measured.
Your personal data has not been programmed. Follow the steps on p.6.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the
measuring platform.
• “OL” appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
Troubleshooting