1. Loosen both set screws on the bracket.
2. Push handle down to lift heating body.
3. Tighten both set screws.
4. Install either letters or makers mark into the letter holder.
5. Slide the letter holder into the t-channel.
6. Turn machine on.
7. Set the temperature (see chart on next page).
8. Allow the machine to heat up, depending on what is in the
letter holder you may need to wait an extra few minutes
after elements have heated for the imprinting face to be hot enough.
9. If using foil, place the foil on the leather under the imprinting
surface with shiny side facing up.
10. Press and hold the imprinting surface in contact with
the material for the amount of time specified on the chart below.
11. Lift the imprinting surface from the material and remove the
material from the machine.
12. Pull the foil off the material.
INSTRUCTIONS
FOR USE
3 9 8 0 - 0 1
T A N D Y P R O
®
M A C H I N E S
H E A T I M P R I N T E R
WARNING:
Heated equipment surfaces can become very hot during operation and can cause
severe burns. Do not touch heated equipment while operating or just after stopping; wait until equipment
has cooled completely. This product is not intended for use by children; adult supervision required.
WARNING:
Choking hazard; small parts. Not for children under 3 years.
Step 1 & 3
Step 7
Step 6
Step 2
Step 5
