INSTRUCTIONS
FOR USE
3 9 7 4 - 0 1
T A N D Y P R O
®
5 - T O N
C L I C K E R P R E S S
MACHINE SET UP:
After unpacking your machine:
1. Firmly bolt the machine body to your work surface. MACHINE IS HEAVY. TWO PEOPLE REQUIRED TO LIFT.
2. Align the holes on the handle with those on the handle connector, then use the included bolt to firmly attach the
handle to the machine.
3. Slide the cutting plate in place on the base of the machine.
MACHINE USE:
1. Place the cutting board into the machine with the non-slip side down.
2. Adjust the resting height of the press plate up or down with the height adjustment know until the press pushes
the die slightly into the cutting surface when the handle is in the down position.
3. With the head swiveled out of the way, place the die over the material in the center of the cutting surface.
4. Pull the handle down until you hear the die “click” through the material, you may need to start on one side of the
die and move across it in stages if the die is larger or has a complex shape.
Hyrdraulic Rod
Handle
Handle Connector
Height Adjustment
Cutting Plate
Base
Position Stopper
