T&S EC-3100 Series, Инструкция по установке и обслуживанию

Страница: 10 / 19

10
General Instructions
OPTIONAL ANTI-ROTATION
FEATURE
Wall-Mount Model: EC-3101
(Figure 2D)
Note: The anti-rotation feature uses a set
screw to anchor the faucet in the vertical
position and is intended for use ONLY on
stainless steel sinks.
Use the mounting hole diagram or fau-
cet base gasket as a template by placing
it in position over the faucet mounting
hole. Mark the stainless steel mounting
surface at the center of the small notch
at the bottom of the base gasket. Drill a
9/32” (7.14 mm) diameter hole through
the stainless steel mounting surface.
Extend the 1/4-20 set screw installed in
the back of the faucet body by unscrew-
ing it (counterclockwise) with a 1/8” hex
key wrench. Unscrew it far enough that
it protrudes past the base gasket and
into the 9/32” drilled hole. Assemble
the washer and nut to secure the faucet
in place.
OPTIONAL ANTI-ROTATION
FEATURE
Deck-Mount Models: EC-3100 &
EC-3102
(Figure 2E)
Note: The anti-rotation feature uses a pin
to anchor the faucet in position and is
intended for use ONLY on stainless steel
sinks.
Use the mounting hole diagram or the
faucet base gasket as a template by
placing it in position over the faucet
mounting hole. Mark the stainless steel
mounting surface at the center of the
small hole at the bottom of the base
gasket. Drill a 5/32” (4 mm) diameter
hole through the stainless steel
mounting surface. Install the faucet
aligning the pin with the small hole.
Assemble the washer and nut to secure
the faucet in place.
Note: The pin can be removed with
pliers if not needed.
Figure 2D
Figure 2E
EC-3101 MOUNTING HOLE
DIAGRAM
Ø1” THRU
1 9/32”
Ø9/32”
For Anti-Rotation
EC-3100 & EC-3102
MOUNTING HOLE
DIAGRAM
Ø1” THRU
Ø5/32”
For Anti-Rotation
1”