6
General Instructions
Installation of Gooseneck w/ Side Spray Assembly, Included in
B-2743, B-2744 & B-2749 Assemblies:
1. With water supply and drain lines shut off from step 1 in Installation of
Gooseneck Assembly, drill a 7/8” diameter hole in countertop where no.8 (center
body assembly) is to be installed. The hole should be no more than 6” maximum
from center of hole for side mount mixer. For rigid gooseneck assembly no.8
(center body assembly) and no.7 (gooseneck) are one assembly. For the swivel
gooseneck assembly no.8 (center body assembly) and no.7 (gooseneck) are
separate assemblies.
2. Remove no.12 (set screw) from no.7 (gooseneck) with fl at head screw driver.
Carefully twist and pull no.7 (gooseneck) from no.8 (center body assembly). No.14
(diverter valve) should be visible in top of no.9 (center body shank) of no.8 (center
body assembly). With fl at head screw driver, turn screw in top of no.14 (diverter
valve) counter clockwise to loosen valve. Remove no.14 (diverter valve) from top
of no.8 (center body assembly) and set aside. With 3/4” wrench use fl ats on no.9
(shank) to remove no.8 (center body assembly) from no.13 (valve body). Remove
no.11 (nut) and no.10 (washer) before placing no.9 (center body shank) of no.8
(center body assembly) through hole above countertop. After installing no.8
(center body assembly) in 7/8” diameter hole, put no.10 (washer) and no.11 (nut)
back on no.9 (center body shank) below countertop and tighten with 1” wrench
until tight with countertop.
3. Reinstall no.13 (valve body) below countertop on bottom of no.9 (center body
shank).
4. With screwdriver reinstall no.14 (diverter valve) above countertop in no.8
(center body assembly).
5. Connect outlet hose from side mount mixer to inlet of no.13 (valve body).
Tighten snug with 15/16” wrench.
6. Install no.15 (guide assembly) for no.18 (side spray assembly) by removing
no.17 (combo nut washer) from no.15 (guide assembly). Place no.16 (shank) with
bonnet through hole in countertop for no.18 (side spray assembly). Thread lock
nut & washer on bottom of no.16 (shank) of no.15 (guide assembly) beneath
countertop. Thread tightly.
7. Place no.18 (side spray assembly) hose (1/8” NPT) fi tting through no.15 (guide
assembly) on top of countertop until spray handle rests in no.15 (guide assembly).
Below countertop install no.18 (side spray assembly) hose fi tting into bottom of
no.13 (valve body) with 3/8” wrench.
8.
FOR SWIVEL ONLY:
Install no.7 (gooseneck) by installing gooseneck onto top of
shank of no.8 (center body assembly) sticking out top of counter. Install grease
from packet on swivel o-rings prior to installing on no.9 (center body shank).
Install set screws in gooseneck base.
9. Open water supply and check for leaks. Lift handle on side mount mixer and
check for leaks. Use side spray and check for leaks.
