Note: This is a general instructional example of units using -BST.
Nozzles should be installed on unit first.
Nozzle Installation
:
ex. model B-0665-BST
1. Remove no.6 from both sides of no.1.
2. Apply Loctite #680 to threads of no.5 and no.12.
3. Insert no.12 into no.11. Thread no.5 into no.11,
then rotate no.11 into no.1 until tight with no.12
facing front of sink.
4. Replace no.6 into no.1 following
nozzle installation.
no.4 adjusting
screw
Close Stop
turn
clockwise
Open Stop
turn counter-
clockwise
Botton view of faucet body
and Built-in Stop
Faucet Installation
:
5. Shut off water supply and drain
lines. Drill (2) two 7/8” [2.2 cm] holes in wall or
backsplash of sink, 8” [20 cm] center to center,
where you are installing no.1.
6. Apply teflon tape or pipe joint compound to
threads of water supply lines.
7. Remove no.2 from no.1 and attach no.2 to water
supply lines flush against wall. Tighten by hand.
Trim supply lines if necessary.
8. Attach no.1 to no.2, adjusting center to center fit
by turning no.2 if needed. Make sure no.3 remains
in place. Tighten no.2 firmly with a wrench.
9. Turn on water supply and check for leaks.
Adjusting Built-in Stops:
Insert a screwdriver to adjust no.4 at the base of
no.1 on each side. Water should be turned on
for this procedure.
1
2
water
supply
l i n e
3
4
w a l l
Upper Nozzle Support Installation
:
10. Attach no.14 to no.12 by screwing no.14 into clevis on no.12.
11. Position no.17 against wall. Mark holes and secure no.17 to wall using no.15.
apply
Loctite
5
6
clevis
1 4
1 6
1 5
1 2
11
1 7
