TANDBERG Voyager E5784, Справочное руководство

Страница: 11 / 384

Introduction to the Basic Encoder
Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder Page 1-3
ST.RE.E10137.3
1.1 Scope of This Reference Guide
1.1.1 Who Should Use This Reference Guide
This Reference Guide is written for operators/users of the E5784 and
E5788 HD DSNG Encoders to assist in the installation, operation and
day-to-day care. These Encoders are referred to throughout this Reference
Guide as ‘Encoder(s)’ unless there is a specific difference, where they will
be referred to by the model number.
The Encoders can operate with Standard Definition (SD) and High
Definition (HD) modes. Where only one is applicable to an option then the
relevant SD or HD is indicated.
WARNING…
DO NOT REMOVE THE COVERS OF THIS EQUIPMENT. HAZARDOUS VOLTAGES ARE PRESENT
WITHIN THIS EQUIPMENT AND MAY BE EXPOSED IF THE COVERS ARE REMOVED. ONLY
TANDBERG TELEVISION TRAINED AND APPROVED SERVICE ENGINEERS ARE PERMITTED TO
SERVICE THIS EQUIPMENT.
CAUTION…
Unauthorised maintenance or the use of non-approved replacements may affect the equipment
specification and invalidate any warranties.
This Reference Guide does not include any maintenance information or
procedures which would require the removal of covers.
1.1.2 Build Version
This Reference Guide has been written to cover the functionality in
Table 1.1.
Table 1.1: Build Version
E5784, E5788
Build Version 3.9.0 and later
The Build version indicates the status of the Encoder and refers to an
overall number that encompasses all the various software/firmware
versions of video, audio, etc. in the Base Board.
The current Build version can be found in the
Build Menu
(see Chapter 4,
Operating the Equipment Locally, Figure 4.9). This number should be
quoted in all correspondence with TANDBERG Television.
1.1.3 What Equipment is Covered by This Reference Guide
Each model of Encoder comprises an enclosure with a Base Board and
Modulator fitted as standard. The E5784-IF and E5788-IF are fitted with a
IF Satellite Modulator; the E5784-LBAND and E5788-LBAND is fitted with
an L-Band Modulator.