TANDBERG SM6610, Справочное руководство

Страница: 100 / 200

Front Panel Control
Page 4-10 Reference Guide: SM6610, SM6615, SM6620 and SM6625 Satellite Modulators
ST.RE.E10152.2
3. Select the Network Settings menu which is the first item in the
system menu. Press Enter to enter the menu.
4. The IP Address, Subnet Mask, Gateway IP Address and Gateway
Enable State can now be edited. To change an item, select it using the
up and down keys, then press Enter on the item you wish to change.
The current digit being edited is underlined in the following IP Address:
5. Press the up and down arrow keys to cycle through the characters. Use
the left and right keys to navigate along the address. When finished,
press Enter to confirm the change. To cancel the change, press
Cancel.
NOTE…
Erroneous address settings cannot be saved.
4.3 Configuration Options
Table 4.5 lists the options available.
Table 4.5: Configuration Options
Configuration Setting Options
Data Select ASI 1, ASI 2, Null Pkts, PRBS
(
+
ASI 3, ASI 4, SPI with DVB ASI & SPI Input Card option)
Packet Size 188 bytes, 204 bytes
Rate Adapt OFF, ON
Bit Rate xxx.xxxxxx Mbit/s
Symbol Rate xx.xxxxxx Msym/s
Coding Mode DVB
Modulation BPSK, QPSK (
+
8PSK, 16QAM with HOM option)
FEC Rate 1/2, 2/3, 3/4, 5/6, 7/8, 8/9
Roll-off 20%, 25%, 30%, 35%
IF Frequency xxxx.xxx MHz
Uplink Freq xxx.xxxxxx GHz
IF Power xx.x dBm
IF Output OFF, ON
Mod. State OFF, ON
IF Spectrum Normal, Inverted
UpConv Freq xxx.xxxxxx GHz
UpConv Pwr OFF, ON (available only on models SM6615 & SM6625)
UpConv Ref OFF, ON (available only on models SM6615 & SM6625)
Æ
IP Addr :[192.168.055.003

Edit
È
Mask : 255.255.240.000

Mode