18
TANDBERG Videoconferencing System
Getting started
Getting started
System start-up
Your system should be in standby mode. When in standby mode, pressing any key or picking up the remote
control will wake up the system. An incoming call will also wake up the system.
If the system does not respond, make sure the system is switched on by using the On/Off
switch located at the rear of the Codec (see figure below). After a few seconds you should
see a ‘Welcome’ menu on the monitor.
If this does not help, verify that your monitor is switched on. To switch the monitor on you
normally push the power button on the front of the monitor (depending on monitor type).
Welcome menu
After a user-definable boot-up logo is shown, the following menu is shown. This menu should provide you with the
most important system information. For further system information, select the Quick key ‘
System Info
’.
