D13841.08
10.2007
14
TANDBERG
3G GATEWAY
USER GUIDE
The 3G Gateway requires some basic
configurations before it can be used. It will be
necessary to find the IP-address and to create
the dial-in and dial-out services to program
the ISDN-PRI Line numbers.
Make sure the 3G Gateway is
Off
and
connect an RS232 cable between the
3G Gateway and a PC.
Switch on the 3G Gateway.
Start a terminal program on the PC and
configure it to:
115200, 8, 1, None
Configuring via the RS 232
To assign a
static IP-address
, type
Xconf ip Assigment: “Static”
and
Xconf ip address <IPAddr>
To assign an
IP Subnetmask
, type
Xconf ip address subnetmask
<subnetmask>
To assign an
IP Gateway
address, type
Xconf ip address gateway
<gateway IP-address>
Restart the 3G
Gateway.
Start a WEB browser
and enter the IP-
address of the 3G
Gateway. Default
password:
TANDBERG
Note the case sensitivity!
To configure the 3G
Gateway for UMTS
dial-in, enter PRI or BRI
numbers and dial in
number(s). For details,
see
Gateway
.
To configure the 3G Gateway for IP dial in, register the 3G Gateway to a Gatekeeper and
enter H.323 services. For details, see
Configuring the 3G Gateway
As an alternative to the configuration via
RS 232 you may use the LCD panel to
configure and check the IP settings, as well as
to reboot the system. This is outlined on the
next page.
Power switch
Configuring Your 3G Gateway via the RS 232
About Gateway Configuration
Configuration via the Front Panel