D13841.08
10.2007
15
TANDBERG
3G GATEWAY
USER GUIDE
The LCD panel makes it possible to configure
and check the IP settings as well as to reboot
the system. The front panel LCD menu items
are as follows:
The 3G Gateway requires some basic
configurations before it can be used. It is
necessary to configure the IP-address and
to create the dial-in and dial-out services to
program the ISDN-PRI Line numbers.
As an alternative to the configuration via the LCD
Panel you may use RS 232 to configure and the
system. This is treated on the previous page.
UP key
DOWN key
ESC
key
ENTER key
Configuring the IP Address via the Front Panel
Switch on and press any key to produce
the
Main Menu
. Use
UP
/
DOWN
to
navigate to the
IP Settings
, if needed.
Press
ENTER
to access the
IP Settings
submenu.
Use the
UP
/
DOWN
keys to select
IP
Address
.
In addition to configure the IP address you
must also configure the default-gateway,
netmask and set IP assignment to static.
Press
ENTER
again to produce the
cursor.
Use
UP
/
DOWN
keys to navigate
between the digits of the number.
Use
ENTER
to enter
Digit Altering
Mode
.
Use
UP
/
DOWN
to alter the digit value.
Press
ENTER
as many times as needed
to move to the next digit to be altered
and alter this digit.
When finished editing use
ESC
to go to
the
Confirm change
menu.
Use the
UP
/
DOWN
key to select
yes
or
no
and
ENTER
to confirm.
Use
ESC
key to navigate back to the
main menu.
DHCP assigned IP-addresses are supported by the TANDBERG 3G Gateway (factory default).
IP Settings
IP Information
Commands
IP Address
IP Netmask
IP Default GW
IP Address
Reboot
Main Menu
IP Settings
IP Information
Commands
Menu Hierarchy
Configuring the IP Address via the Front Panel
About 3G Gateway Configuration
Configuring via the Front Panel
Power switch
Switching On the Unit
Configuration via RS 232
