Caution!
Be careful not to squeeze fingers or cables.
Rearrange cables if necessary.
D13728.09 Page 5
Wall mount
Warning!
Due to the size and mass of this equipment, it is very important that the wall mount unit is safely installed according to
these installation instructions and that the wall is able to safely support the product. It is highly recommended that this wall
mount unit is installed by trained personnel.
According to Standard IEC60950 3rd ed. the wall is required to support four times the actual load, which implies that a
TANDBERG MXP Profile system must be mounted to a wall which supports:
4x 77kg=308kg/679 lbs (T6000 50”), 4x 61kg=244kg/538 lbs (T3000 42”) and 4x 49kg=196kg/432 lbs (T3000 32”).
1 A) Mount the Wall Bracket to the wall
- Studs/pillars
Make sure that the hooks
on the Wall Bracket
point upwards.
Mount the Wall Bracket
horisontally in desired
hight from floor,
recommended
762 mm (30”).
It is important that the
bracket is fastened to the
studs/pillars, using 4 type
D bolts.
Make sure to select holes
that align with the wall
studs/pillars
1 B) Mount the Wall Bracket to the wall
- Brick/Concrete wall
Make sure that the hooks
on the Wall Bracket
point upwards.
Mount the Wall
Bracket horisontally
in desired hight from
floor, recommended
762 mm (30”).
Use 4 type D bolts
with concrete plugs.
1. Drill a small
initial hole
2. Drill a larger
hole for plugs
3. Mount into
specified
holes with
plugs and
bolts.
Pull cable through
Camera Stand, and
place it behind the
Monitor. Ensure that the
Camera Stand is
properly connected
to the magnets on top
and behind.
Plug cables to Camera
and place camera on
top with velcro.
4 Mount the Camera
2 Mount the Top Module to the Wall Bracket
Tighten nuts
in position
a and b after
mounting.
3 Connect cables and mount the Monitor
762 mm
(30”)
�3,0�mm
(0,1”)
�10,0�mm
(0,4”)
75�mm
(3,0”)
3000/6000
Profile
(Please note that the 32” Monitor
shall be mounted
as described in
5b on page 2).
Connect power
cable and DVI
cable from Top
Module to Monitor
before mounting
the Monitor. Also connect
speaker and amplifier cables.
Align according to arrow lables
and lower the Monitor into place.
Put excess cable length back behind Monitor.
762 mm
(30”
)
HD VIDEO
OUT CODEC
a
b