On the Eject submenu, scroll to
Right
Magazine
or
Left Magazine
,
depending on which magazine you
want to eject and press
Enter
.
The magazine pops forward so that the
front of the magazine is no longer flush
with the front panel.
With one hand, grasp the magazine by
the handle and slide it forward to
remove. Place your other hand under
the magazine to support it and prevent
it from falling.
Note:
If you need to remove the
magazine when the autoloader is
powered off, remove it manually.
On the front panel, scroll to
Commands
and press
Enter
.
On the Commands submenu, scroll
to
Eject
and press
Enter
.
d
1
Unpack the
magazine
This guide contains
a sequence of steps
recommended for
unpacking and
installing a magazine.
Place the carton on an ESD-safe work sur-
face.
Use a utility knife or scissors to cut the
packing tape along the length and ends
of the carton.
Fold open the box flaps.
Reach into the carton and lift out the
magazine and foam.
Remove the foam caps from each end of
the magazine.
Place the magazine on a flat surface and
rotate the assembly using the manual
indexing wheel.
When the carrier assemblies rotate freely,
the magazine is ready for use.
a
b
e
2
3
f
g
c
Remove a
magazine
2
a
b
c
d
Support here. Grasp here.
For additional information:
Refer to the enclosed CD-ROM,
or visit www.tandberg.com
