27
OF
28
The library communicates with the host through the SCSI interface of one of the
tape drive via the Automation Drive Interface (ADI) serial interface.
See the tape drive’s
Product Manual
for tape drive information.
See
Automation/Drive Interface – (ADC)
for ADI information.
3.
Reconnect the power cord and power on the library (press the
I
on the back of the unit),
then power on the host.
The library is now ready to resume operation. The new tape drive defaults to the
following SCSI IDs:
Library
Tape Drive Configuration
SCSI ID
StorageLibrary
T24
Single half height tape drive
3
Two half height tape drives
Upper tape drive
4
Lower tape drive
3
Full height tape drive
3
StorageLibrary
T48
Single half height tape drive
3
Four half height tape drives
Top tape drive
6
Third tape drive
5
Second tape drive
4
Bottom tape drive
3
Single full height tape drive
3
Two full height tape drives
Top tape drive
4
Bottom tape drive
3
!
Important
You may need to reconfigure your backup application to
recognize the new tape drive. Refer to your application’s
documentation for instructions.