10
Tanco Autowrap 1514-1510
Operator’s manual
2.10
SPECIAL INSTRUCTIONS FOR AUTO
WRAP 1510 / 1514 TWIN
These machines must be prepared for
transport in a slightly different way:
1.
Move the main wrapping arm in under the
davit in the transport position by pressing
"Wrap slow"
and keeping it pressed in.
2.
For locking and disengaging the wrapping arm
during transportation, ensure that the locking bolt
for the wrapping arm is fitted. (See section 2.6
and fig. 2-7.)
3.
Loosen the fixing screws for the locking plate
which secures the second wrapping arm in the
working position. Then swing the arm in towards
the davit. (See fig. 2.8.)
4.
To reduce the transport width of the TWIN machines, at the same time preventing the
secondary arm from accidentally swinging out to the side during transportation (see fig.
2.9), each cutting beam is put in the transport position by holding the beam by the edge
and lifting it upwards and inwards by hand. Using a special grooved slot at the back end
of the mounting point, the cutting beam locks automatically in the raised transport
position when the beam is dropped to its lower position once more at the back. (See fig.
2.10.)
(
See also sections 3 to 8 for the standard machines)
