Tanaka TBC-420PF, Руководство по обслуживанию

Страница: 3 / 22

The following safety notations are used throughout this
manual to call attention to special information or operating CAUTION: A CAUTION identifies safe operating
procedures. Understand the message in each notation practices or indicates unsafe conditions that could
and be alert to unsafe conditions and the possibility of result in personal injury.
personal injury.
WARNING: A WARNING describes a condition
NOTE: A NOTE points out general reference information
where failure to follow the instructions could
regarding proper operation and maintenance prac-
result in severe personal injury.
tices.
DANGER: A DANGER designates a condition
IMPORTANT: An IMPORTANT statement indicates spe-
where failure to follow instructions or heed
cific procedures or information that is re-
warning will most likely result in serious injury or
quired to prevent damage to the machine or death.
its attachments.
This safety alert symbol is used to attract your
attention! PERSONAL SAFETY IS INVOLVED!
When you see this symbol - BECOME ALERT -
HEED ITS MESSAGE.
Before test operating or making repairs or adjustments to
the unit, read and understand the operating and safety Gasoline is highly flammable and its vapors are explosive.
instructions in the Owner’s Manual. Handle with care. Use an approved fuel container. DO
NOT smoke or allow open flame (match, pilot light, etc.) or
DO NOT make any adjustment or perform any mainte- sparks near equipment or fuel container when refueling or
nance or repair procedures while engine is running
unless servicing fuel system.
specifically instructed to do so in this manual.
Use non-flammable solvent to clean parts - DO NOT use
DO NOT touch parts which might be hot from operation. gasoline.
Before attempting to maintain, adjust or service, allow
such
Use only approved replacement parts when making
parts to cool.
repairs.
Open doors if engine is run in garage, exhaust fumes
are After all repair procedures are performed, make sure that
dangerous.
DO NOT run engine in an enclosed area.
unit is in good operating condition and all safety devices
and shields are in place and in good working condition. Be
Do repair work in a well-lighted, ventilated area. sure all fasteners are tight, all adjustments are correct and
all tools are removed.
To prevent accidental starting, disconnect wire to spark
plug and position wire away from plug. DO NOT change engine governor setting or over speed
engine.
Always wear satety goggles when cleaning or making
repairs to parts or machine. Never store equipment with fuel in tank inside a building
where fuel fumes may reach an open flame or spark.
When unit is tipped to perform service procedures in this Allowengine to cool before storing in any enclosure.
manual, remove fuel so that no spillage wi l occur.
WWW.TANAKAPOWEREQUIPMENT.COM CUSTSVC@NIKKO-TANAKA-USA.COM
Safety Precautions
Safety Alert Symbol and Notations
all l