ADJUSTING THE HEAD UNIT
The head unit will should come adjusted from the factory. However, riding on rough terrain and
general use may cause the head unit to become loose over time. It may be necessary to adjust
the head unit from time to time.
To adjust the head unit:
1. Rotate the handle bar as far right as it will go to expose
the HEAD UNIT.
2. The head unit bearings are held in place by two 40mm
nuts on the underside. These nuts are separated by a
spacer. The top nut provides the adjustment, while the
lower nut is a jamb-nut intended to hold the adjustment
nut in place.
3. Loosen the lower nut 3-4 turns (fig. 14)
4. Tighten the top adjuster nut to the desired amount, and
then re-tighten the lower jamb-nut.
DO NOT over tighten as it will make it difficult to steer and may damage the bearings.
ADJUSTING THE BELTS
The belts will come adjusted from the factory. However, it may be necessary to adjust
the pulleys from time to time. The belts must be well aligned onto the pulleys otherwise
they may start to rub and chafe, which will result in shortened belt life.
How tight should the belt be?
If the belt is skipping or jumping on the pulley teeth, this is too loose and may
be harmful.
If the belt is making a humming sound when the wheel is turning, this is too
tight and may cause the belt to snap.
(continued on next page.)
Page 11
