tams elektronik
HADES
t
a
ms elektronik
1.2. Accessories
Connection cables
The use of stranded wire is recommended for the connections. Stranded wires consist of
several thin individual wires and are therefore more flexible than rigid wires with the same
copper cross-section.
Connection to
Recommended cross-section
Power supply, tracks and turnouts
> 0.25 mm²
Push-buttons, switches, LEDs
> 0.04 mm²
External push-buttons and indicator LEDs (optional)
You can manually trigger the exit of the trains from the tracks via additional external push-
buttons and/or have the occupancy status of the tracks displayed on additional, external
LEDs. You then need
per siding
:
one push-button 1 x make contact (e.g. item no. 84-5211x or 84-5212x )
one red and one green LED and one series resistor per LED (> 120 Ohm)
Set up a stopping section at the entrance to the staging yard (optional)
For this you need
a bistable relay 12 V (e.g. item no. 84-61111). Note: If you want to control a semaphore
signal together with the stop section, a bistable relay 1xUm is sufficient, for simultaneous
control of a light signal you need a bistable relay 2xUm.
or a relay circuit board RL-2 (kit item no. 72-00055-01 or ready-made module item no. 72-
00056-01)
and, if necessary, a entry signal without train control.
As an alternative to using a relay, you can directly connect an entry signal with train control.
Using motor-driven turnouts or turnouts with servo drive (optional)
If you do not use turnouts with double coil drives as entry turnouts, you will need additional
circuits that enable the turnouts to be switched by means of switching pulses:
for motor-driven turnouts: adapter AMW-1 (item no. 72-00076-01) or AMW plus (item no.
72-00176-01)
for turnouts with servo drive: SD-32 servo decoder for analogue or digital control (ready-
made module item no. 43-00326-01 or ready-made device item no. 43-00327-01)
6 | Getting started
