6
2. To put the lamination temporarily on hold without turning off the machine, user can turn the motor
control switch to “STOP” position. This will cause the motor to stop running and the film will stop
feeding.
3. To resume the lamination job, set the switch to “RUN” position again.
B. SAFETY SHIELD AND FEED TRAY SENSORS
Both the safety shield and feed tray activate sensors that allow the bottom roller to feed film when
they are properly installed. Removal or misalignment of either or both of these items will cause the
LED light to turn on and stop the rollers from feeding even when rollers are engaged. This is a safety
feature that prevents fingers or any loose articles like neckties or straps from getting accidentally
trapped in between the rollers and causing injury or property damage.
C. TEMPERATURE CONVERSION
This machine can display temperatures in either Celsius or Fahrenheit. To change to either one, simply
press and hold the “TEMP/SET” arrow keys simultaneously.
D. GUIDE PLATES
This machine is equipped with guide plates on the left and right sides of the feed tray for proper
alignment of materials to be laminated. For Versalam2700-EP, aside from being able to laminate 27"
wide sheets one at a time, the user can also laminate up to two (2) 8.5"x11" prints simultaneously in
either orientation by aligning them on each of the plates on both sides of the tray.
E. REVERSE FUNCTION
The machine is equipped with a reverse function. By pressing the REVERSE key, the machine will
release documents out from the front of the machine to prevent any jam or damage.
F. FILM SLITTERS
This machine is equipped with safety film slitters in the back of the machine for trimming film in
between sheets of laminated material. Simply slide the cutting edge across the film to remove the
finished material. The short slitter is for 2-side laminated film while the longer slitter is for 1-side
laminated material.
G. COOLING FANS
The cooling fans that come with this machine can be turned on or off. When turned on, these fans
assist in cooling down the finished product, enhancing adhesion and preventing warping particularly
when using thicker films.
