Notes:
When taking a break from laminating, feed a single sheet of regular size copy paper as if
laminate it. As soon as the paper reaches in between the front and back rollers, lift the lever
to separate the top and bottom rollers. To added weight until prevent the film from bunching
around the rollers.
(2) TWO SIDE LAMINATION
LOADING THE FILM
Unpack the upper and lower rods. Remove feed tray. Slide the roll film onto the rods, leaving
equal lengths of rod out of each end. Use the guide marks to position the roll of film. Load the
rods on the laminator.
Note: you cannot interchange the upper and lower rods.
THREAD THE FILM
Read the threading card supplied with each TCC roll of film carefully. Please see the threading
card. Do not mistake the re-enforcing bar for idler roller. To thread the film through the “hot” rolls
& pull rolls, please pull the handle forward to release pressure on all the rollers. Push the film
through the rollers and make sure the film is perfectly aligned at the top and bottom (Note: overlap
will cause the film to deposit residue on the hot roll and pull rolls, so this procedure is critical ) .
HEAT & SPEED ADJUSTMENT VersaLam-1300S
1. After turning on the power switch, the digital screen display will show the pervious temperature
setting .Please set the temperature to 90
℃
(194
℉
) to start the heat process. By pressing
the “
︿
” or “
﹀
” key of the “TEMP/SET”, user can re-set the temperature. The lowest
temperature this machine can be set is 90
℃
(194
℉
). The digital screen display will beep
showing the set temperature for 3 seconds. After that, it will show the actual machine
temperature.
2. Press the “HOT” key for heating once the temperature is set and the heater light will glow.
3. The machine will buzz/beep once it reaches 80
℃
(176
℉
) for at least 3 minutes. This is to
alert the user that the machine will start running. You can stop the beep by setting the motor
speed to 1.
4. Press the “
︿
” or “
﹀
” key of “MOTOR” to set the motor speed for lamination. The table
℃
below gives some common temperature/speed setting for typical uses.
Film Thickness
Temperature
Speed
1.5 Mil (38 Micron) 120
℃
(248
℉
) 3
3 Mil (75 Micron)
130
℃
(266
℉
) 3
5 Mil (150 Micron) 145
℃
(293
℉
) 2
10Mil(250Micron) 155
℃
(311
℉
) 2
