3
GB
2
GB
SPECIFICATIONS
Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000Watt
No Load Speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7,600/min.
Cutting width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .35cm
Line Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.0mm
Net Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.4 kg
GENERAL IDENTIFICATION
2
11
9
1.
Cord Retainer
2.
Motor Housing
3.
Rear Handle
4.
ON/OFF Trigger
5.
Auxiliary Handle
6.
Tool-Link Coupling
7.
Drive Shaft
Assembly
8.
Debris Shield
9.
Trimming Line
10. Line Head
11. Air Vents
3
10
8
1.
The line trimmer must not be used by anyone under
the age of 16.
2.
Keep children, other people and pets away from the
trimmer; the grass which is cut and dispersed may
contain stones and debris.
3.
Always wear suitable clothing when using the
trimmer to prevent head, hand or feet injuries. Use a
helmet, glasses (or visor), high boots (or sturdy
shoes and trousers) and work gloves.
4.
Do not let other people or animals come within 5
metres of the trimmer when in use.
5.
Always check that the trimmer is in good working
order .
6.
Do not use the trimmer if the cutting device is not
secured properly or is damaged.
7.
Before connecting the trimmer to the mains, make
sure that the rotating parts are not damaged and the
wire-holding spool is inserted correctly and securely.
8.
Before starting the trimmer, make sure that the trim-
ming line is not touching stones or debris.
9.
Do not start the trimmer when it is upside down or
when not in working position.
10. When the trimmer is in operation, keep the cutting
section away from all parts of the body.
11. Remain in a stable and secure position while
operating the trimmer.
12. Keep the area being cut free from wires, stones and
debris.
13. Do not cut against hard objects. This could cause
injury or damage the trimmer.
14. Use the edge of the guard to keep the trimmer away
from walls, surfaces, miscellaneous things and deli-
cate objects.
15. Never use the trimmer without the guard.
16. Be careful of the line-cutting blade, which can give
deep cuts.
17. Do not try to stop the trimming line with your hands.
Always let it come to a stop by itself.
18. Do not use the trimmer to cut grass which is not in
contact with the ground; for example do not cut grass
which is on walls or rocks etc.
19. Do not switch the trimmer on in enclosed or poorly
ventilated spaces or in the presence of inflammable
and/or explosive substances.
20. The user of the trimmer is responsible for any dam-
age sustained by third parties which has been
caused by the line trimmer within the working area.
21. Only cut during broad daylight or with corresponding
artificial light.
22. Do not cross roads or gravel paths with the trimmer
still running.
23. Turn the trimmer off and disconnect the plug when:
the trimmer is not being used, it is left unattended, it
is being examined because it is not working correct-
ly, the power supply cable is damaged, the spool is
being removed or changed or when the trimmer is
being moved from one place to another.
24. Do not move the trimmer by holding the electric
cable. Use the central handgrip.
25. When the trimmer is not in use, store it in a dry place
and out of the reach of children.
26. The trimmer should be used in compliance with these
instructions and only in a position which is vertical in
relation to the ground. Any other position is danger-
ous.
27. Check regularly that the screws are properly secured.
28. The mains voltage must correspond to the one
marked on the technical data plate. Do not use other
sources of power.
29. Never pass the grass trimmer over the extension
cable while the grass trimmer is working as this could
cut the cable. Make sure you always know where the
cable is.
30. Use the special cable holder for the connection of the
power cable.
31. Never use the trimmer when it is raining. Try to pre-
vent it from getting wet or being exposed to humidity.
Do not leave it outside overnight. Do not cut damp or
wet grass.
32. The power supply cable should be checked regularly
and before using it each time make sure the cable is
not damaged. If the cable is not in good condition, do
not use the trimmer. Take it to an authorized service
centre instead.
33. Only use an extension cable which is suitable for out-
door work. Keep it away from the cutting area, from
damp, wet or oily surfaces or with sharp edges and
away from heat and fuels.
34. If the supply cord is damaged, it must be replaced by
the manufacturer or its agent in order to avoid a haz-
ard.
STRING TRIMMER SAFETY RULES
4
5
6
7
1
•
DEBRIS SHIELD
Shield fits snug on shaft. Some force may be required.
1. Seat shield (B) onto shaft bracket (C).
2. Insert washers (D) onto bolt.
3. Insert bolt (E) and nut (F), tighten securely.
• HANDLE ASSEMBLY
NOTE:
The handle is attached to
the shaft but has been turned
under for ease of packing.
1. Loosen adjustment knob and
rotate handle to top of shaft.
Position handle 160mm -
220mm from the rear handle
(Fig. 2).
2. Tighten adjustment knob (A)
securely.
•
DRIVE SHAFT
Installing the lower shaft
1. Remove the hanger from the lower shaft (A). Press the
release lever (B) while pushing the lower shaft into the
tool-link couping. (Fig. 3A)
2. Locate and lock the release lever into the primary hole
(C) in the shaft. (Fig. 3A).
3. Tighten the knob (D) securely clockwise before using
the unit. (Fig. 3B)
ASSEMBLY INSTRUCTIONS
Fig. 2
A
CAUTION
: Make sure the release lever is
locked in the primary hole and knob is
securely tightened before operating this unit.
CAUTION
: All attachments are designed to
be used in the primary hole unless otherwise
indicated in the specific attachment’s opera-
tor’s manual. If the incorrect hole is used, it
could result in injury, or damage to the unit.
B
A
Fig. 3A
Fig. 3B
C
D
WARNING
: The debris shield must be installed
(Fig. 1) to properly dispense trimming line and
protect operator.
B
C
Fig. 1A
Fig. 1B
F
E
D
