Tally Dascom 1125, Руководство пользователя

Страница: 50 / 104

Tally Dascom 1125
36
Adjust Physical Margins
Adjust Page Margins allows for adjustments of physical left, top margins and tear-off position. Warning: Once
these settings are changed, resetting the printer to factory defaults will not initialize these settings back to the
original settings; so it is not advisable to perform this adjustment unless it is absolutely necessary.
Adjust Top Margin Procedure:
1. Enter the Adjust Page Margins function by holding down the
【
Load/Eject
】
and
【
Online
】
keys while
powering up until the printer beeps twice.
2. Load paper.
3. The printer will print as below:
Adjust Page Margins:
【
LF/FF
】
=OK
【
Tear/Off
】
= Back
【
Load/Eject
】
= Next
【
Online
】
= Exit
Current Setting: Adjust Fanfold Top Margin
Press
【
LF/FF
】
key to confirm selection if the paper used is fanfold type. The printer will print as
follows:
Procedure
：
Install fanfold paper to tractors
【
LF/FF
】
= Add
【
Load/Eject
】
= Reduce
【
Online
】
= Exit
Each step is 0.5 mm
Function of keys:
【
Tear Off
】
key: Decrease 0.5mm
【
Load/Eject
】
key: Increase 0.5mm
4. Press
【
LF/FF
】
key, printer will print “Save settings
？
Yes ”. Press
【
Load/Eject
】
key to choose Yes
or No
，
then press
【
LF/FF
】
key to confirm selection and exit “Adjust Page Margins” mode by
pressing
【
Online
】
. The print head moves to the left side and the printer beeps twice, then the print
head moves to the middle position.
Adjust Left Margin Procedure:
1. Enter the Adjust Page Margins function by holding down the
【
Load/Eject
】
and
【
Online
】
keys while
powering up until the printer beeps twice.
2. Load paper.
3. The printer will print as below:
Adjust Page Margins:
【
LF/FF
】
=OK
【
Tear/Off
】
= Back
【
Load/Eject
】
= Next
【
Online
】
= Exit
Current Setting: Adjust Fanfold Top Margin
4. Press
【
Load/Eject
】
key until the current setting is “Adjust Fanfold Left Margin”. Press
【
LF/FF
】
key to
confirm selection if the paper used is fanfold type. The printer will print as follows:
Adjust Fanfold Left Margin 0