16
Firmware Update
Unplug all inputs/outputs from the module. Connect
the output of your audio interface or sound card to
the
IN input jack. Set the FREQ knob to 12 o’clock.
Power on your modular system while holding the
POLY
button, then release. Both LEDs should blink amber.
When you are all set, play the firmware update file into
the module. While the module receives data, the
POLY
LED will blink green, and the
MODE LED will monitor
the signal level. Signal reception is optimal when the
MODE LED is green or yellow. Try adjusting the FREQ
knob to change gain. The module will periodically
pause to write data to its permanent memory. Both
LEDs will be amber during these pauses. When the
end of the audio file is reached, the module will
automatically restart. If it doesn’t restart, please retry
the procedure.
If the signal level is too weak, the LEDs will blink red
in an alternating pattern. Press the
POLY button and
retry with a higher gain. If this doesn’t help, try the
procedure from a different computer or audio interface,
and make sure that no other equipment (such as an
equalizer or FX processor) is inserted in the signal
chain.
