Talking House Talking House Outdoor Antenna Kit (for..., Инструкция по эксплуатации

Страница: 6 / 7

OUTDOOR
ANTENNA
CONNECT
ANTENNA
SELECT
TWO-PART
MESSAGE
SELECT
Part 1 Part 2
CUSTOM POWER
INPUT
120 VAC
Remove key to prevent changes
to message or frequency
Basic Outdoor
ISD4004-8
SPEAKER VOLUME
Must be OFF when using a
microphone to avoid feedback
18 VDC
BACK-UP MICROPHONE:
Speak into vent on cabinet top
LINE INPUT
500mV
PP
/10K
WITH AGC
TRANSMIT MODE SWITCH
Message Chip Live Radio
5 minutes
OUTDOOR
ANTENNA
CONNECT
ANTENNA
SELECT
TWO-PART
MESSAGE
SELECT
Part 1 Part 2
CUSTOM POWER
INPUT
120 VAC
Remove key to prevent changes
to message or frequency
Basic Outdoor
ISD4004-8
SPEAKER VOLUME
Must be OFF when using a
microphone to avoid feedback
18 VDC
BACK-UP MICROPHONE:
Speak into vent on cabinet top
LINE INPUT
500mV PP /10K
WITH AGC
TRANSMIT MODE SWITCH
Message Chip Live Radio
5 minutes
Step Action
1
Connect one end of the Coax Cable to the COAX Connector on the bottom of the ATU.
2
Connect the other end of the Coax Cable to the Outdoor Antenna Connect located on the
back of the i A.M. Radio Transmitter.
3
Remove the clear plastic protector from the Antenna Selection Switch located on the
back of the Transmitter and move the switch to Outdoor.
RESULT: You will now see a red light on the Display Panel located on the front of the Transmitter,
indicating that the Outdoor Antenna is now in use.
Connecting the Outdoor Antenna to the i A.M. Radio Transmitter. Follow the steps below to
connect the Outdoor Antenna to the i A.M. Radio Transmitter.
NOTE: The Coax Cable that attaches the Outdoor Antenna to the
i A.M. Radio
Transmitter comes
in 100' length. Do not attempt to adjust the length of the cable by cutting it. This will
jeopardize performance. You may coil any extra cable and secure it with a tie.
step 1
step 2
step 3
ATU
ATU