Talking House Talking House Outdoor Antenna Kit (for i.AM.Radio), Инструкция по эксплуатации

Страница: 4 / 7

Step Action
1
You’ll need to purchase a five-foot length of one inch diameter metal pipe in a five foot length
and drive this into the ground where you want the antenna installed.
2
Open the pole mount hardware kit (supplied).
3
Place the 4 screws through the screw holes in the Mounting Brackets on the ATU box.
4
Attach one pole clamp onto the top screws, and one pole clamp onto the bottom screws, so that
the jaws are facing the ATU. Slightly tighten the wing nuts to prevent the clamps from falling off.
5
Slide the clamps over the pole and fully tighten the wing nuts.
6
Screw the fiberglass whip antenna onto the top of the ATU.
Temporary Mounting of the Outdoor Antenna. Use the steps below to temporarily mount
the Outdoor Antenna at a location, using the pole mount method. This would be used any
time you need some extra distance to reach listeners at a location where the Transmitter
is likely to be moved after a short period of time.
step 6
step 3
step 4
step 5
TIP:
Remember that
the higher you
mount the antenna
from the earth, the
further your signal
can reach.