4
Setup Instructions
Turn on the TTMT Switch Interface, using the on/off switch located on
the side of the interface box. You will see a red power light to indicate the
interface is turned on.
Ensure the Switch Interface is connected to the wego via Bluetooth.
1. Exit the communication software (if you are unable to exit the software,
you may be in Guided Access. See Guided Access, page 5 for
instructions on leaving Guided Access).
2. Open the
iOS Settings
then select
Bluetooth
. Ensure Bluetooth
is toggled On. Under
My Devices
, you should see TTMT Switch listed
as
Connected
. If not, tap on “TTMT Switch” to connect. You may see a
pop-up Bluetooth Pairing Request, if so, press
Pair
.
3. Once the Switch Interface is connected via Bluetooth, you can plug in
your switches and begin setup.
Connect your Switch or Switches to
the TTMT Switch Interface
The Switch Interface can be used with one or two switches. For single-
switch scanning, plug your switch to Switch Port 1. For two-step scanning,
plug in both switches, with your “chooser” in Port 1 and your “mover”
switch in Port 2.
Note – once all settings are adjusted, see instructions for resuming Guided Access
(Page 5).
