Talex Eco CUT 135 135mini, Оригинальное руководство пользователя

Страница: 10 / 93

TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail. biuro@talex-sj.pl
en.talex-sj.com
10

The User Manual should be kept on the machine. When letting the machine to other
user, you must ensure that it is in good mechanical condition, and that the User
Manual is also handed over.

It is prohibited to attach any additional means of transportation to the mower.

During commissioning, check the machine functions and make the initial
adjustments, without a load.

Assembly protection of the three-point hitch of the mower with pins, should be
made only using the typical secure cotter pins. Using any other break-back devices is
prohibited.

Due to the natural wear, you must control the condition and completeness of the
machine cutting tools, following the instructions laid out in Chapter 7. Operation and
maintenance

On receipt of the mower after its transportation, you must make sure that the
machine has not been damaged and check its mechanical condition.

It is forbidden to stand under the raised mower, as it may result in being crushed by
the machine.

When adjusting, do not place your fingers and limbs between the structural elements
of the machine.

It is forbidden to leave a tractor’s cabin when the machine is running, and before all
the rotating parts have stopped

Operator of the vehicle working with a mower, must ensure that no person is
approaching the machine during its operation, and
the distance of not less than 50m
from the working mower is always maintained.

Before switching on a mower’s drive, lower the cutting unit to its working position.

Mowing may be started only after PTO reaches the nominal speed of 540 rpm. It is
forbidden to overload the PTO shaft of the mower, and engage the clutch suddenly.

When turning, reversing or manoeuvring with the machine, you must ensure that
your visibility is adequate, or get assistance from a properly trained person.

It is prohibited to perform mowing while reversing the vehicle. When reversing, lift
up the machine.

When connecting the hydraulic lines, make sure that the hydraulic system is not
pressurized.

It is forbidden to stand between the vehicle and the mower, while the vehicle’s
engine is running.

Working on slopes exceeding 10% is not allowed.

Pay special attention when working on slopes.

When driving on curves and turning, switch off the PTO drive.