PRODUCT SPECIFICATION
名称
:
Installation manual for crystalline
solar photovoltaic modules（Half Cell）
SPEC.NO.
TS-ET-xx
REVISION
A0
EFFECTIVE DATE
03-2020
Page
5
of
27
Suzhou Talesun Solar Technologies Co., Ltd
Address: No. 1 Talesun Road, Changkun Industrial Park, Shajiabang Town, Changshu, Suzhou, Jiangsu Province, 215542, P.R.China
Website:
Email:
Tel: +86 400 885 1098
5 / 28
Do not wear metallic ornaments or metallic devices while installing or troubleshooting photovoltaic systems.
WARNING! Danger of injury due to broken glass! Risk of injury due to falling modules!
The modules are primarily made of glass and must therefore be handled with appropriate caution.
In order to ensure safe mounting, familiarize yourself with all applicable national regulations for
work safety and accident prevention.
Wear suitable protective clothing (e.g. safety shoes, protective gloves) in order to prevent injuries.
If the front glass is broken, or the back sheet is torn, contact with any module surface or the frame can cause electric
shock.
Under normal conditions, a photovoltaic module is likely to experience conditions that produce more current and/or
voltage than reported at standard test conditions. Accordingly, the values of ISC and VOC marked on this module should
be multiplied by a factor of 1,25 1,25 when determining component voltage ratings, conductor current ratings, fuse
sizes, and size of controls connected to the PV output
Modules rated for use in this application class may be used in systems operating at greater than 50V DC or 240W, where
general contact access is anticipated. Modules qualified for safety through this part of IEC61730 and IEC61730-2 and
within this application class are considered to meet the requirements for safety class
Ⅱ
2.2
PRODUCT PRECAUTION
Do not attempt to disassemble the modules.
Do not remove any attached nameplates or components from the modules.
Do not open the junction box under any circumstances.
Only carry out modifications to the modules that have been confirmed by Talesun in
writing in advance.
Do not carry out any extra drilling (e.g. for fasteners) on the modules.
Use only insulated tools that are approved for work on electrical installations.
Do not use light concentrators (e.g. mirrors or lenses) to attempt to increase the capacity of the module. The module
may be damaged. This also voids the warranty.
2.3 TRANSPORT AND STORAGE SAFETY GUIDELINES
Inappropriate transport and installation may break the module. To prevent damage of the modules:
Transport the modules in their original packaging until installation.
Store the modules securely in cool and dry rooms. The packaging is not weather-resistant!
Protect the modules against scratches and other damage, especially from impact at the edges or improper storage.
Ensure modules do not bow under their own weight.
Do not rest a module unprotected on its edges. This can damage the module and the frame.
Do not lift or move the modules using the cables or at the junction box under any circumstances!
Do not set the modules down hard on any surface.
Do not subject the module surfaces to mechanical stress.
