4.
Step 3.
Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 8)
Step 4.
Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 5
.Remove the hanger pin, lock pin and set
screws from the top of the motor assembly.
Step 6.
Route wires exiting from the top of the
fan motor through the collar cover, canopy
cover, canopy and then through the ball /
downrod. (Fig. 8A)
Step 7.
Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig.8A). Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the locking
pin through the hole near the end of the hanger
pin until it snaps into its locked position, as
noted in the circle inset of Fig. 8A.
Installing the blade
Step 1
. Disassemble the top housing
from the motor body by loosening the 6
screws from the top housing.(Fig. 5)
Step 2
.Locate the blade bracket in the
bottom of motor housing, insert the
blade through the slot in housing. Align
holes in blade and blade bracket and
secure with 3 screws and fiber washers
provided. Repeat the process with the
other blades. Reinstall the top housing to
the motor body. (Fig. 6)
Figure 5
Top housing
Screws
Blade bracket
Figure 6
Top housing
Screws
Blades screws
Blades
Blade bracket
Fiber washers
Hanging the Fan
REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly:
Step 1.
Remove the decorative canopy
bottom cover from the canopy by turning
the cover clockwise.(Fig. 7)
Step 2.
Remove the hanger bracket from
the canopy by loosening the two screws on
the bottom of the canopy in 1/4" from the
screw head and turning the canopy
counter clockwise.(Fig, 7)