7
5)
Turn on TMC-734D, monitor and connected device etc..
●
Immediately turn off all the equipments and recheck the connection if nothing appears on a
monitor screen.
6)
Adjust the aperture and the focus of the lens while watching the screen image of the monitor..
・
Adjust the lens mount position in the following way if it has difficulty in focusing (e.g., by using
non-standard lens).
7)
Select the electronic shutter speed to suit the intended use by the
⑭
shutter switch as needed.
8) S
elect the white balance mode to suit the intended use by the
⑩
W.B selector switch as needed.
Adjusting method of Lens mount position
・
Mount the lens used and loosen all three hex-head screws
③
.
・
Move the lens mount back and forth and focus a camera on the far point with the lens focus of infinite distance.
・
Tighten all three hex-head screws at the point where it comes into focus.
Cautionary notes about Electronic shutter
・
Smear may appear when the intense light falls onto the CCD imaging area in E.I(Electronic iris) and high speed
shutter mode. (it is not the camera-related failure.)
・
The flickering phenomennon may occur at commercial power frequency in the lighting environment such as
fluorescent lamp or mercury lamp. If the phenomenon gets to a serious extent, use the camera with
⑭
Shutter
switch turned OFF.(In this case, it is recommended to concurrently use Auto iris lens.)
A high-frequency lighting may also contribute to reduce the phenomenon.
・
The flickerless function(F.L) is the effective function to reduce a perceptible flicker. It is effective only at 50Hz
commercial frequency area for NTSC standard monitor.
Cautionary notes about White balance mode
・
AUTO tracking mode(AUTO) or Push-lock white balance mode(P.W.B) is efficient way to take a white balance
under the luminous surroundings where it is difficult to take a white balance in the preset mode (Light bulb mode,
Fluorescent light mode1, Fluorescent light mode2).
・
It is effective to employ AUTO tracking mode(AUTO) where the lighting environment varies with time
(cf.around-the-clock monitoring) However a white balance may not properly be taken under the luminous
surroundings where the amount of light is extremely low or the flicker emission is very high.
・
Adjustment of white balance in P.W.B mode is more efficient by doing it while capturing the white object and
displaying it in full-screen.
・
In P.W.B mode, a white balance can be set in most luminous surroundings but it has not the function to auto
tracking the variation of luminous surrounding.(It is needed to manipulate a W/B adjust button(B) in each case.)
