Takeuchi 12820004, Руководство оператора

Страница: 113 / 182

111
MAINTENANCE
After First 50 Hours (New Machines Only)
4. Using a filter wrench, turn the filter (4)
counterclockwise and remove it.
5. Clean the surface of installation of the filter
stand.
6. Apply a thin layer of oil to the packing of
the new filter.
7. Install the new filter by hand.
Tighten 2/3 more turns after the filter
packing comes in contact with the surface
of installation.
8. Remove the oil supply cap (2).
9. Add oil up to the upper limit (H) of the
dipstick (1). Problems could arise if the oil
level is either too low or too high.
10. Tighten the oil supply cap (2).
11. Start the engine, run it at low idle for about
3 minutes, then stop it.
12. After about 10 minutes, inspect the oil
level.
Replacing the Engine Oil and Oil Filter
Stop the engine and allow the machine
t o c o o l d o w n b e f o r e p e r f o r m i n g
maintenance.
¡
The engine, muffler, radiator and many
other parts of the machine are hot
directly after the engine is stopped.
Touching these parts will cause burns.
¡
The engine oil is also hot.
Be careful when loosening caps and
plugs. Working on the machine under
these conditions could result in burns.
1. Place a pan for catching the spent oil under
the drain plug (3).
2.Remove the drain plug (3) and drain the
oil.
¡
When a drain valve is included
2. Remove cap (A), install connector (B) and
drain the oil. (The oil comes out when the
screw is tightened.)
3. Remove connector (B) and install cap (A).
IMPORTANT: Check the spent oil. If it
contains large amounts of metal powder,
consult a Takeuchi sales or service outlet.
3. Tighten the drain plug (3).
WARNING
G4G005
1
2
4
L
H
B
A
3
F4G008