Operating
Instructions
General Specifications, Model 750
General Specifications,
Model 750
Size (Approx.):
17.12W x 12.38H x 18.50D
Shipping Weight:
26 lbs (12 KG)
Electrical:
110/120VAC, 50/60HZ,
4 AMP FUSE
take-a-label.com
•
• 16900 Power Dr., Nunica, MI 49448 • 616.837.9300
Note:
The TAKE-A-LABEL dispenser is shipped
mounted to a base to prevent shifting in the container.
1. Remove the machine from the base.
**Always load the TAKE-A-LABEL dispenser with
the On-Off switch in the (OFF) position.**
2. To load a roll of labels on the TAKE-A-LABEL, using
the Unwind Blade to grip the inside of the core.
3. It may be necessary to raise or lower the height of
the Unwind Blade to cut into the 3” core.
4. Thread the loose end of the labels under and up the
front of the peel plate.
5. Pull the labels over the top of the peel plate far
enough to reach the waste take-up roll.
6. Remove the waste wind clip, thread the label
backing paper under the clip, and reinsert clip
over loose paper.
7. Position the Photo Eye or Micro Switch Assembly by
loosening the wing nuts and moving assembly to the
right or left, so the sensor is at or near the center of
the labels. The Photo Eye or Micro Switch Assembly
can be tilted forward or backward by loosening the
mounting bracket’s vertical adjustment wing nut.
8. Turn on the On-Off switch. The waste wind shaft
will turn, winding up the backing paper and dis-
pensing a label at the top of the peel plate. When
the Photo Eye or Micro Switch senses the dispensed
portion of the label, the motor will stop. As each
label is removed, the machine will operate until the
next label is in position to be removed. (CAUTION:)
Turn off switch before removing wound up waste.
9. If the labels tend to follow the backing paper over
the top of the peel plate instead of peeling off, then
there is insufficient tension on the web of the labels.
Loosen the Nylon Tipped Set Screw and unscrew the
Unwind Tension Knob to desired tension.
10. If the motor stalls there may be to much tension
and it may be necessary to unscrew the Unwind
Tension Knob most of the way.
Operating Instructions for the TAKE-A-LABEL Model TAL-750HD-18
TAL-450 Model Shown
