3
Preparation before Installation
CAUTION
Do NOT apply weight or Do NOT hit a thing
on the equipment.
Avoid leaning on the mirror, hard wiping of the mirror
when cleaning. Do not hit a drier etc. to the equipment.
This may cause deformation, breakage or falling accident
of the product.
Do NOT use the equipment outdoors.
This equipment is neither design for nor approved for
outside installation. If installed outdoors, there may be
a danger of a fire, electric shock, or failure.
Remove chemical immediately after attached.
If chemical such as hair dye, comes in contact with the
equipment, wipe it off immediately.This may cause
discoloration or deterioration.
Use this equipment at an ambient temperature
from 5 °C to 35 °C, and humidity from 45% to 85%.
When used at high temperature and high humidity, there may
be a risk of burnout damage, failure deformation discoloration.
Prior to installation, determine the installation position of the product referring to the
specification drawings
.
Provide the wall with a composite panel with a minimum thickness of 9 mm, or a wooden
stud with a minimum strenght equivalent to that of a composite panel of 9 mm.
z
z
Confirm the rated voltage and the power
supply voltage of the equipment.
If overvoltage is applied, a fire may start. Applying
overvoltage will shorten the life of lamp.
z
z
Ask a licensed electrician to perform electrical work.
Perform Class D grounding (previous Class 3 grounding) with the ground wire.
z
Confirm installation directions (up, down, left, right) of the equipment.
Provide the wall with a power supply.
(Refer to the specification drawings for the power supply.)
z
