Adjusting Preset Positions
Installation Manual
1
Turn on the power switch and move the chair to the desired position.
2
With the chair in that position, turn off the power switch.
▼
Electronic beep is emitted.
3
Keep pressing until you
hear an electronic beep.
UP/DOWN foot switch
1
Control Panel
1
ON
3
2
OFF
Control Panel
Approx. 3 seconds
WARNING
NOTICE
3
Although chair settings are previously set when shipped from the factory, you can reset them
to positions that suit your needs.
* The legrest is set to the lowest position (folded up) in order to prevent interfering with
surrounding equipment due to faulty or unintentional operation during installation.
3
Press and hold the preset switch where you want
to save the setting (P1 or P2), and turn on the
power switch. Keep pressing the preset switch for
approximately three seconds.
4
Setting is completed when the electronic beep is
emitted. Return the chair to its original position
by using the auto-return switch, and use the
preset switch to check the set position.
Be very careful when setting the position of the legrest that the
customer's leg will not contact equipment or other items near the chair or
other items.
Perform desired position setting of the preset function with a person sitting in
the chair. As this chair is equipped with a shockless device, setting the desired
position without someone sitting in the chair will result in slight variation of the
final operating position.