TAKACAT Sport, Руководство пользователя

Страница: 6 / 12

Takacat - Asia, Middle East & Australia Page | 6
STEP 7:
Unroll the inflatable floor and insert into its position. There is no need to get it perfectly under each
hull tube, but the rear of the floor should be flush with the Lower Transom Bar.
Insert D-Rings on the bottom of the air deck floor, through the slots in the boat floor fabric layer. Lash
the two D-Rings together with the included webbing strap.
STEP 8:
Inflate the floor to 10 psi. While inflating the airdeck floor, be sure to pause and walk on the floor to
push it into place. Don’t forget to activate the check valve by pressing down on the centre pin and
turning it ¼ turn in either direction. If it is popped up it wont let any air escape. When taking the
pump out, do it quickly as you wont loose much air. NB: If you are finding the valve leaking a little air
after pumping up, this is common as the boats are handmade and the valves can loosen when
packing for shipping. Just use the valve and tighten a ¼ turn and it should tighten the valve again.
STEP 9:
Inflate the Inflatable Seat. The seat can be inflated to a pressure that is most comfortable. The seat is
designed for comfortable rowing and can also be used as a throwable flotation device if needed. 10.
Assemble each oar and install. Be sure to attach retaining nut to prevent losing oars when in use.