TAJIMA TFMX-IIC, Руководство пользователя

Страница: 34 / 268

How to use each part
20
Chapter 2
(2)
USB memory
Prepare a commercial item. USB memory is used for the following cases.
When registering the design (saved in the USB memory) into the machine memory
When saving the design (saved in the machine memory) into the USB memory
When installing the software in the machine
Some type and/or capacity of the USB memory could not be used for this machine. In this case, buy the
USB memory recommended by Tajima. For details, consult the distributor.
For using the USB memory, observe the items to notice described below.
2-1-3.
Rear
(1) LAN port
Use the LAN port when connecting the LAN cables.
(2)
LAN cable
Please prepare a commercial item. LAN cable is used for connecting a personal computer with the
machine. Setting of the operation panel is necessary additionally.(
→ p.193)
When you insert the USB memory, do not mistake the direction of connector. The USB
memory and its inside card could be damaged.
Do not insert the USB memory into the connector in the state that dirt and dust are
attached to the inside of the connector.
Insert a USB memory slowly and gently.
Insert a USB memory upright against the port (insert slot). Oblique insertion could
damage to inside card due to interference of connector with the card.
Wait for five or more seconds after inserting or taking out a USB memory, and then start
operation. It may take about one minute at a maximum to recognize data.
CAUTION
!
LAN port
USB port
LAN cable